Paco 25HP Water Pump 700GPM 90TDH End Suction w/ U.S.Motors E832 3Phase 230/460V

Manufacturer: Paco

Model: 11-401271A6261

Condition: Used. This pump is in Fair cosmetic condition.  The whole thing was repainted at least once, and it could use a new paint job again.  The pump housing has lots of rust outside, and light deposits inside.  The motor has residues in the vents and by the grease fittings.  There are areas of scuffs/missing paint all over.  The drain plug is rounded-off and pretty well stuck in the bottom of the housing.
The photos show the exact item(s) the buyer will receive.

Notes: This pump is in Good working condition.  We removed this from a decommissioned facility. At our facility, we noticed the flex coupler gives a quiet grunching noise when the shafts are connected.  We disconnected the shafts for a quick check.  The pump turns quietly, easily and smoothly with moderate hand pressure on the shaft.  The motor turns smoothly and easily with moderate hand pressure on the shaft also, but gives a quiet grumbling noise from the bearings.  When we ran the motor, we noticed it has a slight whine at speed.  We tried to drain the housing using the drain bolt, but the head of the bolt rounded instead of opening.  We left the bolt in place and used a small pump to drain the casing instead.  No other testing was done.
No manuals, cords/cables, or additional items are included if not listed or shown.

Included:

• (1) Paco 11-40127 Pump with U.S. Motors 25HP Motor

Specifications:

• Paco Smart Pump
• Paco Cat.No.: 11-40127-1A6261
  • Rated flow: 700 GPM
  • TDH: 90
  • Imp. Dia.: 9.9? (hard to read!)
  • Type L end suction pump (type LF frame mounted)
  • Centrifugal pump
  • Double volute design for higher efficiency, lower life cycle costs
  • Integrally cast diffuser vane reduces turbulence and need for suction guides
  • Back pull-out design enables maintenance without disturbing piping
  • Not self-priming
  • Must not be run dry
  • Model series 40127
  • Flange diameter: 10" inlet, 9" outlet
  • Coupling guard over flexible coupler
  • Lovejoy flexible coupler
  • Inlet: 10" flange, 5" opening
  • Outlet: 9" flange, 4" opening
• Motor: U.S. Electrical Motors (Emerson)
  • US Motors ID: E832,S01R313R019F
  • Power: 25 Horsepower
  • Volts: 60Hz 3phase AC, 230V 64.8A or 460V 32.4A, usable on 208V 74A
  • S.F.: 1.15
  • Speed: 1760RPM
  • Code: G
  • NEMA design: B
  • NEMA nominal efficiency: 89.5
  • Rated for continuous duty at 40ºC
  • Frame: 284T
  • Type: D DP drip proof
  • Good for across the line starting

30 Day Guarantee

• Guaranteed to be as described
• Can be returned for flaws or malfunctions that were not disclosed
• See complete terms

CDN Systems LLC, DBA Doug Deals, is not an authorized distributor or affiliated with the manufacturer of this product. Original manufacturer's warranty does not apply.